Robot for Ladle Maintenance – Ladle Monocator  
 
 

COMPUTER CONTROL

Specific areas of the working lining can easily be selected from more than 30 pre-set programmes held in the computer memory. The ladle side wall and bottom are displayed in an unfolded view on the VDU screen showing high wear areas such as the slag line and around the purge plugs.

 

The software is designed to accurately control the location, depth and thickness of the refractory material which has been specially developed to give good adhesion and minimum rebound during application.

CAN BE USED IN THE HOT OR COLD CONDITION

One of the main features of the Ladle Monocator is the fact that it is designed to treat ladles that are still hot. This generates large fuel savings by cutting down on the time and energy required in the pre-heating stages of the ladle cycle.

 

The bottom of the ladle is especially prone to wear and the Monocator is programmed to spray accurately around the purge plugs and in any other bottom areas which require repair.

Designed to be user friendly, the main screen display makes it easy to target areas such as the slag line.
Screen showing ladle bottom with purge plug area selected for repair.
 
<< Previous | Next >>
 
 
   Copyright © Monocon International Refractories Sitemap | Disclaimer